Solid-State Output Interval On Timers - TH3L Timers

Solid-State Output Interval On Timers - TH3L Timers


	TH3L Timers TH3L timers are solid-state output units with digital timing. The TH comes in a 2" square case. Ease of installation and hook-up is a primary design benefit. All models with integral time adjustment knob or factory-fixed time require only three connections. Units with external time adjustment have two additional terminals for the resistor or potentiometer.
Timing Mode Application of input voltage to the timer energizes the load and starts the time delay. At the end of the time delay, the load is de-energized. Removal and re-application of input voltage re-sets the timer.

FEATURES
Digital timing, solid-state output 1 Amp current load handling 10 Amps single AC cycle surge handling 3 Operating voltages 24, 120 and 230 VAC .1% Repeat accuracy Virtually unlimited time ranges Factory-fixed or variable-timing adjustment Totally encapsulated for protection from harsh environments	O-ring sealed exposed controls Single screw mounting through center mounting hole Standard 6.35mm (.250") quick connect blade terminals Three terminal connections allow convenient substitution for other manufacturers’ timers 100% Operational testing before shipping

BASIC WIRING AND DIMENSIONS

SPECIFICATIONS
Repeat Accuracy: 0.1% under fixed conditions Timing Ranges: 0.1 sec. to 24 hours (1 sec., 10 sec., 100 sec., and 1000 secs. are standard.) Special time ranges available upon request Reset/Recycle Time: 200 milliseconds Tolerances: Fixed: ±10% of nominal time (optional: – ±5%, ±1%) Variable: -0%, +15% Limit: -10% at minimum time Recycle Effect: None Temperature Ranges: Storage: -40° C to +85° C Operating: -25° C to +85° C		Life Expectancy: No predictable failure if used within operating parameters Protection: Transient Protection: 18 joules Dielectric Strength: 1800V RMS 60 Hz Power Requirement: .25 watts max. Weight: 3 oz. (85g) maximum Load Current: 1 amp continuous, 10 amps single AC cycle surge Time Cycle Interrupt: Resets timer to original state (Input Voltage Break)

SELECTION PROCEDURE

Mode of Operation

Series

Input Voltage

Time Ranges

Time Adjustment Method

Interval On Delay

TH3L

1 120 VAC
50/60 Hz

2 230 VAC
50/60 Hz

3 24 VAC
50/60 Hz

Variable Time Periods

0001 .1 to 1 sec.
0010 .1 to 10 sec.
0100 1 to 100 sec.
1000 10 to 1000 sec
Any range up to 24 hours available on special order.

Fixed Time Periods

Specify in seconds (S) or hours (H)
Examples: