|
|
TEK Flashers
TEK Flashers
|
|
 |
Tek Flashers
Tek flashers are an ideal substitute for mechanical flashers. They have no moving parts and are designed to mount onto a circuit board. The CMOS timing provides excellent accuracy and repeatability. |
Timing Mode
Application of input voltage to the timer starts the time delay. At the end of the delay period, the load is energized. To reset, remove the input voltage to the timer.
|
 |
|
FEATURES |
- Digital timing, solid-state output
- Up to 1 amp current load handling
- 10 Amps single-cycle surge handling
- Wide voltage range from 24 to 240 VAC and 12 to 48 VDC
- .5% Repeat accuracy
- Time ranges up to 1 second
- No moving parts
|
-
Totally encapsulated for protection from harsh environments
-
Board mounting by center mounting post
-
Standard 6.35mm (.250") quick connect blade terminals
-
Optional wire leads
- 100% Operational testing before shipping
|
| BASIC WIRING AND DIMENSIONS |
 |
| SPECIFICATIONS |
|
Repeat Accuracy: 0.5% under fixed conditions Timing Ranges: 0.1 sec. to 1 sec. factory-fixed Tolerances: Fixed: 10% of nominal time Temperature Ranges:
- Storage: -40° C to +85° C
- Operating: -25° C to +65° C
Life Expectancy:
- No predictable failure if used within operating parameters
|
|
Protection:
- Polarity Protection: All DC units are bi-polar
- Dielectric Strength: 1800V RMS 60 Hz
Solid-State Output: N.O. Load Current: 1 amp switching, 10 amps single-cycle surge Time Cycle Interrupt: Resets timer to original state (Input Voltage Break) |
| SELECTION PROCEDURE |
| Mode of Operation |
Series |
Input Voltage |
Time Ranges |
Time Adjustment Method |
| Flasher |
TEK |
U 12-48 VDC
24-240 VAC |
Fixed Time Periods
Specify in seconds (S) or hours (H)
Example: S is seconds |
C Fixed, internal, factory set |
|
|
