This transducer is used with process control and industrial instrumentation equipment. The DC output signal can be connected directly to a high impedance analog input of a computer or PLC without additional signal conditioning.

The CR4310 series will measure up to 200% of full scale on a short time basis (1 minute or less) and 150% on a continuous basis at its rated accuracy. To protect external circuits from damage caused by short circuits or motor inrush currents, the output is limited to 12 Vdc.

Self-powered, requires no external power source Permanently calibrated Output overload protected Interfaces with most commercially available instruments Fully isolated 10 different ranges	Calibrated Signal Out: 0-5 Vdc Frequency: 50/60 Hz Response Time: 250 ms max., 10-90% FS Max. Signal Out: 12 Vdc	Industrial Instrumentation Equipment Process Control Over/under current sensing