Process Controller,Pixsys,Electronics,ATR11Process Controller,Pixsys,Electronics,ATR11Process Controller,Pixsys,Electronics,ATR11Process Controller,Pixsys,Electronics,ATR11Process Controller,Pixsys,Electronics,ATR11

Process Controller Pixsys Electronics ATR11

description

Programmer / process controller size 72x144mm. Programming of 9 cycles, max. 15 steps each.

Available models are equipped with 2, 5 or 7 relay outputs (check ordering codes), programmable for command, alarm/auxiliary functions and one analog input for thermocouples, RTDs, linear signals.

Ideal for electrical and gas kilns, including the management of motorised valves with Open/Close logic.

Special software functions make the programmer suitable for kilns and furnaces: Recovery mode allows the firing prosecution also after power failure, foreseeing a recovery step with programmable rise gradient to continue the firing process from the point of interruption; Waiting function is particularly useful in case the kiln is unable to reach the programmed temperature in the given time: the function enables the extension of segment until the final setpoint value is achieved for each step of the firing profile.

Process Controller

Ideal Application

Single/multi-zone kilns and furnaces
Gas burners control
Temperature and humidity control

Technical data

SIZE: 72x144(frontal)x117mm
POWER SUPPLY: 24Vac, 230Vac, 115Vac ±15% -50/60Hz
POWER CONSUMPTION: 5 W
DISPLAY: double, 4 red digits, 12 status LEDs, single digit display for visualization of cycle
OPERATING CONDITIONS: 0-45°C, 35..95rH%
INPUTS:
1 analog configurable for TC J, K, S, R, T, B, PT100, NI100, O..10V, 0-4..20mA
4 digital inputs (optoisolated)
OUTPUTS:
2 relays 10A resistive (version ATR11-01020X)
5 relays 10A resistive (version ATR11-01050X)
7 relays 10A resistive (version ATR11-01070X)
CONTROL MODE: ON/OFF, PID-Autotuning
ACCURACY: 0.5%±1digit for TC/RTD, 0.2%±1digit for V/mA
SAMPLING TIME: 250ms
SEALING: IP54 Frontal, IP30 Box, IP20 Terminal blocks
CONFIGURATION: parameters protected by password
9 programmable CYCLES - 8/13 STEPS each
SPECIAL FUNCTIONS:
Recovery of interrupted cycle
Waiting function



Hirotronix,Sensors,Solutions,Inc

Site Design: Process Controls And Instrumentation