Replace Sliprings with Mercotac Electrical Sliprings - Model 830
Model 830
Eight Conductors,
2@4amps, 6@30amps
Disconnects included
(4 sm., 12 lg.)
Boot kit available
Available with stainless steel ball bearings (830-SS)
Model No.
Terminals
Voltage AC/DC
Amp
Rating @240VAC
Max.
Freq. MHz
Contact Resistance
Max. RPM
Temp Max. F (C) /
Min. F (C)
Rotation Torque (gm-cm)
Circuit Separation
830
8
0-250
2@4/6@30
100
1036
<1m
200
140 (60) /-20(-29)
1000
>25M
830-SS
8
0-250
2@4/6@30
100
<1m
200
140 (60) /-20(-29)
1000
>25M
"SS" designator indicates stainless steel ball bearing (recommended for wet or corrosive environments)
830 Accessories
55110
22 - 18 AWG (qty. 4 included)
55253
Shrink Tube (qty. 6 included)
55252
Terminal 16 - 14 AWG
(qty. 6 included)
2627
55251
Terminal 16 - 14 AWG
(qty. 6 included)
57830
Boot Kit for dust or splash protection
IP51
Terminals for other wire gauges available.
(22-18 AWG and 12-10 AWG)
830
Standard Wire Connections
830
Wire Connections With Optional Boot Kit
830 Suggested Mounting Methods
Model 830 is typically mounted
by either the black body or the white plastic bushing on either end using a set screw.
When mounting horizontally, mount the Mercotac so the body of the connector rotates.
Typical Body Mount Hole Dimensions
MODEL
HOLE DIAMETER () *
DEPTH
830 et al
1.772" (45.00)
.80" (20)
Typical Bushing Mount Hole Dimensions
830 et al
1.125" (28.58)
.40" (10)
*Inch (mm) Tolerance
+.001" (+.025)
-.000" (-.000)
Installation Notes:
the up arrow should not point
below horizontal
do not solder to or bend connector
tabs
avoid lateral forces and
mechanical loads (overly stiff or tight wires)
do not rigid mount both ends of
connector
7A5
limit mounting eccentricity (runout
/ wobble) to .005" (.13mm)
830 Accessories
