Use the right tool for the job! Cleveland Eastern Mixers offers a line of pre-engineered mixers for bulk drum mixing when standard portable mixers are not adequate for viscous, solid suspension or special blending applications.

Heavy-duty mounting bridges are designed to fit each manufacturer's drum frame, whether it's wire cage, steel or plastic. The bridges are fitted with lock down clamps, lifting handles, and splash-guard tank seals.

Models are offered for direct drive applications with horsepower of ½ to 2 HP, utilizing chemical duty, TEFC, EXP motors or air motors.

Buy with confidence. Only EMI warrants its bulk container mixers for 3 years.

Specifications

Standard Bulk Drum Models

• Specify single or three phase motor: 115/230/60/1 or 230/460/60/3 TEFC, 1.15 Service Factor
• Air Motor: Variable Speed 600-2000 RPM
• Powder Coated finish
• All 316 Stainless Steel wetted components

ELECTRIC MODELS Output speed 1750 RPM
Model#	BCE-½	BCE-1	BCE-2
Horsepower	½	1	2
Max Shaft Length	32"	32"	35"
Prop Size	5"	6"	(2) 6"
Weight	35 lbs.	50 lbs.	60 lbs.
Pumping Capacity in water	510 GPM	680 GPM	1360 GPM

AIR DRIVEN MODELS Output speed variable 600-2000 RPM
Model#	BCA-½	BCA-1	BCA-2
Horsepower	½	1	2
Max Shaft Length	32"	32"	35"
Prop Size	5"	6"	(2) 6"
Air Pressure	40 psig	80 psig	80 psig
Cubic Feet/Minute	20	40	70
Weight	25 lbs.	30 lbs.	45 lbs.
Pumping Capacity in water	510 GPM	680 GPM	1360 GPM

Options

• Optional Output Speed with gear drive: 350 RPM
• PVC, Rubber and other coatings available
• 10' Line cord with switch for single-phase motors
• Explosion proof, Chemical duty, Washdown, 50 HZ, 100 to 575 Volt or 1425 RPM motors available
• Air lubrication set including filter, regulator and lubricator recommended for air driven models

Engineered Bulk Drum Mixers for Specialty Applications

For viscous or heavier materials, gear-driven models ranging from ½ to 3HP are available with speeds from 45rpm to 350 rpm. Low headroom, right-angle drives are used to allow for stacking and operating well below OSHA dB noise specifications.

Three impeller designs are available. Single, dual and triple impellers can be used. A unique four bladed collapsible axial flow impeller fits through a 5¾" opening and can open to 18". This provides exceptional blending for viscous materials or suspending fine solids without "dead spots" often created by mixing with small propellers.