Pneumatic Drum Pump Motors from Standard Pump

SP-A2 Series
 
Pneumatic, Drum Pump, Motors, Standard Pump
Engineered for use in heavily corrosive environments or when aggressive fumes are present.Ideally suited for transferring flammable / combustible liquids.
Pneumatic, Drum Pump, Motors, Standard Pump
Model
Consumption
Max. Inlet
Pressure
Ouput
SP-A2
28 CFM@90 psi
100 psi
3/4 hp
 
13.2L/sec@6.2bar
6.8 bar
560w

Downloads

SEE WARNING AT BOTTOM OF PAGE.
SP-A1 Series
 
Pneumatic, Drum Pump, Motors, Standard Pump
Engineered for use in heavily corrosive environments or when aggressive fumes are present.Ideally suited for transferring flammable / combustible liquids.
Pneumatic, Drum Pump, Motors, Standard Pump
Model
Consumption
Max. Inlet
Pressure
Ouput
SP-A1
22 CFM@90 psi
100 psi
1/2 hp
 
10.4L/sec@6.2bar
6.8 bar
370w

Downloads

SEE WARNING AT BOTTOM OF PAGE.

WARNING: Pumping of flammables or combustible liquids can generate a static electric discharge, causing fire or explosion resulting in injury or death. Read and understand operating instructions before starting this unit. Follow all federal, state and local safety codes including NFPA 30 - NFPA77. Prior to connecting to air supply, install bond and ground wires and check continuity of each wire. A meter reading of one ohm or less is required for safe liquid transfer. Use only metallic drum, receiving
vessel and metallic pump (SP-SS) when pumping flammables. Air motors are not recognized under any current Underwriter’s Laboratory listing program. Consult a qualified engineer for suitability for use in a hazardous area or on flammables.