This is a Vertical or Horizontal Positive Displacement Drum Pump, which can be used with the following Flux motors:

Maximum Viscosity Material for this pump is 50,000 cP.

The stator is an easily exchangeable push-in stator, which can be either of solid material or a steel shell, vulcanized with an elastomer specific for the application. On the inside of the stator rotates the eccentric rotor which is driven by a stainless steel shaft from the planetary gear unit below the motor. (max RPM 900)

This Vertical or Horizontal Positive Displacement Drum Pump is very easy to dismantle for cleaning. By releasing the top union nut, the motor can be removed. When the lower union nut is released, the gear reducer, drive shaft and rotor can be withdrawn from the stator and outer tube. Stator can be removed by unscrewing (reverse thread) stator houing at bottom of tube. Tools are not required for this operation.

Uses Std. FLUX Air or Electric Motors

• Output to 7 GPM
• Head to 275 feet
• Max: Viscosity 50,000 cP
• Choice of 5 Stator Materials
• Teflon Stator Std.
• Choice of Pump Length
• Easy Cleaning
• Easy to Dismantle
• Tools Not Required
  
  

Motors	F410 EX UL & F408 TEFC F450 EX, F448 TEFC. F416 & F416-1
Pump Tubeset Materials Outer Tube Shaft Eccentric Rotor Stator Materials Immersion Depth. Standard Immersion Depth. Special	Stainless Steel 316 Ti. Stainless Steel 316 Ti Stainless Steel 316 Ti. See listing below 27", 39" or 47" 19" to 47" in 4" increments
Outer Tube Diameter Eccentric Rotor Dia Thread of Hose Connection Hose Connection Weight of Pump (Depending on Motor Used).	2" (50mm) 7/8" (21mm) R 1½" 1", 1¼" or 1½ (2" special) 14 to 28 lbs.

Stators Available Elastomer Stators NBR -- Buna -- N. Black NBR -- Buna -- N. White (Food Ind.) CR -- Neoprene -- White (Food Ind.) FPM -- Viton® Solid Material Stators PTFE -- Teflon

Accessories Drum Compression Gland 2". Ground Wire. Container Clamp. Flat Bottom Stator Housings for Bagged Containers.