EP Series End Suction Centrifugal Pumps
The EP Series end suction centrifugal pumps are of a rugged cast iron design. Suitable for a wide variety of markets including irrigation, industrial, commercial and marine. These pumps are engineered to provide you with long reliable service.
CASING - Ductile iron casing with reinforcing ribs for higher working pressures and greater resistance to water hammer.
IMPELLER - Vacuum cast bronze impeller provides smooth flow passages for improved performance. Cast iron impellers are also available. All impellers are dynamically balanced, with hydraulic balancing included on larger models.
SEALS - Frame mount and JP motor driven pumps are available with either gland packing or single, double or tungsten carbide mechanical seals. JM motor driven pumps are available with single or tungsten carbide mechanical seals only. All seals are equipped standard with stainless steel springs and retainers.
SHAFT SLEEVE - Stainless steel with O-ring seal, for maximum protection against shaft corrosion.
WEAR RINGS - Provided in all pumps to prolong casing life and to allow close tolerances for improved efficiency.
SUCTION FLANGE - On all pumps for simple piping connection. A complete line of companion flanges are available to convert suction to NPT if required.
DISCHARGE FLANGE - On all models. Discharge may be rotated to eight different positions to better suit your exact requirements.
ELECTRIC MOTOR DRIVEN - Close coupled JP motors in ODP or TEFC for a compact, economical design. JM motors up to 15 HP.
FRAME MOUNT - Heavy duty bearing frame allows for belt or coupling drive, with bearings sized for improved life. A variety of frames are available for each pump, allowing you to tailor the pump to your needs.