The 8632C accelerometer is ideally suited
for modal analysis. The convenient cubic configuration provides flexibility for installation. Three surfaces are suited for adhesive
mounting, allowing quick removal. The small, lightweight design reduces mass loading in multichannel applications.
High sensitivity and high
thermal rejection are featured in this series. These ground isolated accelerometers are housed in a hard, anodized package for protection against adverse
conditions. The PiezoBEAM design producs outstanding phase response and a wide frequency range. The 8632A is available in
three ranges with sensitivities as high as 1,000 mV/g.
The built-in charge amplifier provides low impedance, voltage
output, allowing for high-noise immunity and insensitivity to cable motion. Standard, low-cost cables can be used because of the low
impedance output. This PiezoBEAM will operate directly from the ICP compatible internal power source found in most FFT analyzers.
A wide selection of Kistler Piezotron® power supply couplers are also available.
• Low impedance voltage mode
• High sensitivity
• Small, cubic design
• Ideal for modal analysis
• Excellent thermal stability
• Conforming to CE
The 8632C accelerometer is ideally suited
for modal analysis. The convenient cubic configuration provides flexibility for installation. Three surfaces are suited for adhesive
mounting, allowing quick removal. The small, lightweight design reduces mass loading in multichannel applications.
