The force sensor is mounted under preload
between two nuts and, therefore can measure compression and tensile forces. The quartz element yields an electric charge
which is proportional to the force. This is picked off by an electrode and transferred via a connector.
The
charge signal is fed via a screened cable to a charge amplifier, which converts it into a proportional output voltage.
An appropriate evaluation circuit can record and further process the measurand. The sensor is mouled ground-isolated. This
largely eliminates ground loop problems.
• Calibrated force link
• Simple installation
• Centering seats for accurate fitting
• Ground-isolated
• Accessories for optimum force introduction
The force sensor is mounted under preload
between two nuts and, therefore can measure compression and tensile forces. The quartz element yields an electric charge
which is proportional to the force. This is picked off by an electrode and transferred via a connector.
