750 Series II Conductivity/TDS Monitor/Controller

Conductivity, Monitors, Controllers, 750 II Series, Myron L, CompanyThe unique circuitry of our 750 Series II Conductivity Monitor/controllers guarantees accurate and reliable measurements. Drift-free performance is assured by "field proven" electronics, including automatic DC offset compensation and highly accurate drive voltage.

Since Temperature Compensation is at the heart of accurate water measurement, all Myron L Monitor/controllers feature a highly refined and precise TC circuit. This feature perfectly matches the water temperature coefficient as it changes. All models are corrected to 25°C. The TC may be disabled to conform with USP requirements.

Built-in electronic calibration allows for fast quality checks.

A push-to-test button makes setpoint checks easy, while the internal alarm set discourages unauthorized adjustments.

Standard on all controller models is a heavy-duty, 10-amp output relay, operating on either increasing or decreasing readings. Bright green/red LEDs indicate readings above or below setpoint.

Digital and Analog 750 Series II models have an IP65/NEMA 4X water-resistant & corrosion-proof rated enclosure. At 152 x 122 mm/6 x 4.8 in., all models are suitable for panel, bench or surface mounting.

Additional options include a 3 Sensor Input Switch and/or a 3 Range Switch and a Remote Alarm™ model RA.

Sensor - CS51LC, CS51 and CS52

Conductivity, Monitors, Controllers, 750 II Series, Myron L, CompanyThese reliable sensors feature an integral temperature sensor to ensure accurate and rapid automatic temperature compensation. The sturdy polypropylene bushing is modular for easy inexpensive replacement. Several alternatives for the metal portion of the sensor are available, depending on the demands of the application.

CS51LC sensors (0.1 constant) are used for 5 and below.

CS51 sensors (1.0 constant) are used between 0-10 and 0-20,000.

CS52 sensors (10.0 constant) are used above 20,000.

Low cost, low temperature, low pressure sensors available upon request. See 750II Sensor Selection Guide.


  • Reverse Osmosis

  • Process Control

  • Seawater Desalination

  • Waste Treatment

  • Food Processing

  • Plating

  • Power Plants

  • Laboratories

  • Printing

  • Aquaculture

  • Agriculture

  • Environmental Studies

  • Medical

  • Boilers (250 psi @ 205°C)

  • Cooling Towers


  • 34 Conductivity/TDS ranges: 0- 1 microsiemens/ppm to 0-200millisiemens/ppt

  • Choice of 3½ digit display or analog meter

  • Automatic temperature compensation to 25°C

  • Isolated 0-10 VDC Recorder Output standard

  • IP65/NEMA 4X water resistant and corrosion proof enclosure

  • Built-in electronic calibration

  • Single set point/alarm standard

  • Adjustable setpoint hysteresis

  • Solid State 24 VDC Output

  • 10 amp relay operates on choice of increasing or decreasing reading

  • LEDs show "above/below" Alarm/control status

  • Push-to-test set point check

  • Internal set point discourages unauthorized adjustment

  • Selectable 115/230 VAC

  • CE Certified

  • Reliable, easily installed sensors

Sensor Specifications

  • Temperature Compensation: Integral thermistors provide automatic TC to 25ºC between 0-100ºC/32-212ºF.

  • Pressure /Temperature Limits: CS51: 100 psi / 690 kPa @ 100°C/212°F. 250 psig @ 205°C, Models CS40 and CS41 sensors available on special order.

  • Bushing: Modular Polypropylene threaded 3/4” NPT. 1/2” PVDF or 316 stainless steel fittings available as option.

  • Cable: Shielded 10 ft./3 meters standard 25 and 100 ft./ 8 and 30 meter lengths available. 100 ft./30 meter is maximum recommended.

  • Dimensions: CS51: Metal portion 30 L x 13 Dia. mm/ 1.2 L x .5 Dia. in.

Search This Site

(Search by Product Type i.e. Level or Brand Name i.e. Walchem)


About Us

Metex Corporation Limited has been providing superior products and services to the process control, chemical treatment, waste water, industrial and manufacturing industries for over 25 years. It is our goal to continually provide our customers with the best possible equipment, technology, and service.


Our Products

Dataloggers, sensors, pumps, recorders, hand held instruments, flow instrumentation, level controls, valves, instrumentation, containers, tanks, transmitters, data loggers, digital indicators, mixers and agitators, pressure intrumentation, analyzers and controllers for a variety of industrial applications such as water quality, pH/ORP and more.

Website Content

Water Analyzers and Controllers, Wireless Products, Corrosion Monitoring Equipment, Cooling Tower and Boiler Controllers, a wide variety of Pumps, Valves, Dataloggers and Recorders, HVAC, Instrumentation, Skids and Systems, Containers and Tanks from world leading manufacturers are products you will find on this site.

Get in Touch