Cabinet Panel Cooler Accessories - Filtration, Hose Distribution Kit, Sealing & Mounting
Cabinet Panel Cooler Accessories for Frigid-X Cabinet Panel Coolers and are supplied with a 5 micron filter which comes with an automatic float type drain and a hose distribution kit.
Cabinet Panel Cooler Accessories Hose Distribution Kit comes complete with a length of flexible clear vinyl tube which is used to direct cold air to hot spots in the enclosure and to circulate the cold air. Clamps to hold the tubing and a silencing muffler are also included along with adhesive backed clips to hold the tubing in place.
Cabinet Panel Cooler Accessories Hose Distribution Kit and Muffler further reduce noise levels but also act as an emergency trap for moisture should the filter fail for any reason, protecting your enclosure controls. The filter protects against moisture and in fact stops allmoisture from entering the control panel. The air entering the control panel from high pressure to near atmospheric conditions and will stabilize at 45% relative humidity.
For this reason Cabinet Panel Cooler Accessories are useable for humidity control as well as cooling - truly an "air conditioner".
If there is potential for oil in the air lines our Model 90005 oil removal filter (to 0.03 micron) is recommended. Nex Flow Frigid-X Cabinet Panel Coolers should be mounted on the top or side (using our side mount kits) but near the top as much as possible, they should also be mounted vertically.
Solenoid Valve And Thermostat For The Cabinet Cooling System With Frigid-X Cabinet Coolers
Cabinet Panel Cooler Accessories are available with a standard two-way normally closed solenoid valve and thermostat kit Model 90015 (120V) or Model 90016 (240V). This limits the flow of air only when required. The thermostat is factory set at 95ºF (35ºC) and will normally hold +/- 2ºF (1ºC) inside the enclosure. It is rated 24V-240V, 50/60Hz. Ul recognized and CSA approved.
Thermostat And Solenoid Valve Kit
This kit comes complete with a solenoid valve, thermostat, and a resister. The resister is included should you encounter rapid temperature fluctuations in the control panel causing the solenoid to cycle on and off to quickly (chattering). The resister is installed (if needed) across the leads of the thermostat and prevents chattering by dampening the thermo switch sensitivity.