Eagle® Water-Stik

Eliminate dust problems at conveyor transfer points for less $$$ !

A safe, inexpensive Dust Suppressor that's truly cost-effective. The Eagle^® Water-Stik performs every bit as well, if not better than all the "sophisticated" higher-priced units.

Factory assembled and requiring only simple water and electrical hook-ups, the Water-Stik is the answer to instant compliance and the end of costly citations.

The Water-Stik sprays only when media is present where dust is liberated (usually just before a transfer point). When the belt is not running, no water is sprayed.

EAGLE WATER-STIK

SPECIFICATIONS

AC Input...............................................120 VAC 15 W

Fuse Protected.................................................2 amp

Minimum Operating Speed..........................100 RPM *

On-Time Delay..........................................2 Seconds

Maximum Water Pressure...........................500 P.S.I.

GPM's @ 400 P.S.I........................................  .8 GPM

* Speeds below 100RPM - use two targets