HVAC,Temperature,Transmitters,Rotronic,T,Series

HVAC Temperature
Transmitters Rotronic T Series

  HVAC Temperature Transmitters Rotronic T Series
  100% compatible with the F and F65 series humidity HVAC transmitters
Specifications Installation
  • Temperature measurement from -30 to 70°C / -22 to 158°F (depends on model).
  • 100% compatible with the F and F65 series humidity HVAC transmitters
  • High quality Pt100 RTD temperature sensor: ±0.3°C accuracy
  • T series for commercial HVAC applications
    TW65 for special HVAC applications (NEMA 12 enclosure)
  • Competitive pricing

T2C-W

T2C-D

   TW65W-2C

Specifications
Note: Range of output signal is limited to a maximum span of 100°C / 180°F

Model Installation
Type		 Circuit Type
Supply Voltage		 Output
Signal		 Standard
Ranges		 Temp. Limits
at probe		 Dimensions
T2C-W wall 2-wire, loop powered
10VDC + 0.05 x Load		 4-20 mA 0..100°F
-30..70°C, 0..100°C
consult factory
for other ranges
(see note above)		 -5..50°C
23..122°F

116 x 70 x 40 mm
ABS Case
170 g

T3V-W 3-wire
10..35VDC / 24 VAC		 0-5 V
T3C-W 4-20 mA
T2C-D duct mount 2-wire
10VDC + 0.05 x Load		 4-20 mA -30..70°C
-22..158°F

154 x 72.5 x 48 mm
ABS Case
420 g

T3V-D 3-wire
10..35VDC / 24 VAC		 0-5 V
T3C-D 4-20 mA
TW65W-2C

wall

2-wire
10VDC + 0.05 x Load

4-20 mA

-5..50°C
23..122°F

154 x 72.5 x 48 mm
ABS Case
IP65 / NEMA 12
400 g
TW65W-3V

3-wire
10..35VDC / 24 VAC

0-5 V
TW65W-3C 4-20 mA

Installation
Modular Design for Simple, Problem Free Installation and Easier Maintenance

Each T series transmitter consists of a base plate and a measurement module (electronics, probe and sensors). The transmitters are calibrated at our factory and are shipped in an individual box for protection during shipment or storage.
Step 1

The base plate is mounted and wired
(a standard electrical box may be used in the case of a wall installation). Since the measurement module is not required during this part of the installation, it can be safely stored until all the work is completed.
Step 2

Upon completion of the wiring work, the module is just snapped into the base plate and secured with the screws provided. Any module can be installed with any base plate, no special matching is required.

When it is time to re-certify calibration or if a repair is required, simply replace the module. Rehabilitated, fully calibrated and certified replacement modules are available from RIC.


Handheld Temperature
Indicators Rotronic T51/T55

Site Designed By Panther Marketing & Design