Description
The PT449 Direct Cavitiy Pressure Transducer is a miniature pressure
transducer that mounts directly in the mold, flush with the cavity surface.
The transducer does not depend upon knockout pins, thus eliminating
pin hangup and improving measurement accuracy. The PT449 is used to
measure peak cavity pressure, the most accurate and repeatable way to
initiate the holding pressure phase
Features
- Mounts flush with cavity
- Sensing tip can be shaped down 0.05"
- Direct contact with material
- Withstands 400°F mold and 600°F
melt temperatures
- 6 mm sensing area (4 mm available)
- Standard 80% shunt calibration
|
|
