De-Solv-it
- Petroleum Based Nontoxic Degreasers Citrus Solvents
De-Solv-it
Petroleum Based Nontoxic Degreasers Citrus Solvents are
ideal for applications where water based cleaners cannot
be tolerated.
Cleans everything from greasy machinery to filled cables
to paint-covered hands. Removes everything from blood stains
to oil marks to chewing gum.
Reusable as contaminants will separate from material.
Will not mix with water so water can be used to help separate
contaminants.
The #1 solvent! Excels at
removing tar, asphalt, oil, grease, chewing gum, and more!
Proven exceptional on greasy, oily, sticky problems. Written
up safe in medical journals. And it is 100% organic, biodegradable
and SAFE.
In addition
to its many outstanding industrial uses , De-Solv-it®
has been used to remove tar and asphalt from and around
burn victim wounds and as an effective eye wash. Written
up in such prestigious medical publications as American
Journal of Surgery and Emergency Medicine Journal, De-Solv-it®
has passed safety tests for:
• Eye Irritation
• Inhalation Toxicity
• Muscle Tissue
• Oral Toxicity
• Primary Skin Irritation
In fact, De-Solv-it® has been used as an adhesive and
tar remover in trauma centers, hospitals, and care facilities
across the U.S. De-Solv-it® passed Independent Safety
Tests for: Draize Eye Irritation, Inhalation Toxicity, Muscle
Tissue Toxicity, Oral Toxicity, and Primary Skin Irritation.
De-Solv-it Uses
Shop Production Floors
Pour De-Solv-it on the floor. give it frm a few seconds
to a couple of minutes to work. Move from one place to another
with a squeegy. Once the area has been cleaned, the De-Solv-it
can be picked up with a wet-dry vac, washed into a sump
drain or picked up withan oil absorbant material. Works
great on oils, greases, gum and adhesives.
Tanker
Clearners
Spray the entire tanker, inside and out with De-Solv-it.
Allow to sit for a few minutes. Then hit it with your power
wash. For some heavily incrusted areas a second application
may be necessary. The water will wash the De-Solv-it into
your recovery system where it can be pumped off and re-used.
Oils,
Grease, Resins
Allow tools or parts to soak
in De-Solv-it for several minutes. Remove and wipe off with
a dry cloth. For teh removal of residue from machinery.
Use a fine spray or rag with De-Solv-it and wipe the areas
that need to be cleaned. In areas of heavy build up more
than one application may be needed.
Electrical
Parts & Equipment
Dip parts to be cleaned in De-Solv-it (hot or cold). Keep
the solution moving to wash away the residues. For GEL in
Cables, dip in DeSolv-it or wipe on with a rag, spray on
and then wipe dry with a clean rag. For PC Boards, wipe
dry with a clean rag or blow dry after cleaning. Will not
hurt wires, cables, computers or electrical motors. Has
a 50,000 volt dielectric strength.
Parts
Washers - Sonic Cleaners - Dip Tanks
Allow the parts that need to be cleaned to soak in De-Solv-it
or have the solvent flushed over the parts for a few minutes.
Remove and wipe dry or blow dry with an Air Hose. With our
low evaporation rate we need thses methods if speed is important.
The contaminents will fall to the bottom during periods
of non-use. Use heated or cold.
Tar
and Asphalt Removal
Sprau a small amount or pour a few drops on the affected
area. Move the De-Solv-it around lightly to loosen the top
layer. Within a few minutes the residue should be removed.
Works fine in removing tar and ashphalt from clothes and
skin.
Adhesive
& Sealant Removal
For Hot Melt Machines, labeling machines and work areas
where adhesives and some sealants are used. Spray or wipe
on a coat of De-Solv-it. Allow a couple of minutes for penetrating
the residue. Where tape is to be removed, peal back the
carrier after a couple of minutes of soak time (for double
faced tape it may take a longer soak time) wipe with a clan
cloth. For Silicon rubber and Sealant it may take up to
1 1/2 hours of soak time.
Transformers
Use De-Solv-it in Dip Tank to remove oils anf grease from
parts. It works well on new parts as on used parts. It has
been used on new and re-built transformers. De-Solv-it is
being tested for use a a heat
transfer fluid.
More
Degreasers
Products
