NOTE
THESE FEATURES ...
- Can holder will rotate
through 360 degrees and lock in any position for shaking
operation. To change position, release pressure of friction
type locking plates by lifting end of locking lever at
top of shaker, rotate to desired position, re-lock by
pressing downward on end of locking lever, and set timer
for required mixing time, or flip switch for manual model
(shown) ... a MATTER OF SECONDS.
- Bottom end clamp is recessed
to prevent slippage. Cans should be loaded in upright
position, the top calmp tightened using screw handle provided,
then rotated and locked in upside down position, then
shaken to loosen sedimented pigment. The mixing is best
accomplished in a nearly horizontal position. A four inch
high block should be used under one gallon cans and cartons
to center the load.
- Positive action clamp
will not loosen.
- Ball bearing throughout,
prelubricated at factory, doubly sealed - no maintenance.
- Eccentric drive mechanism
proven by 22 years in the field.
- Explosion proof motor
and switch, or 0-30 minute timer optional.
- Fully guaranteed to perform
satisfactorily. Parts warrenteed for one year.
WHAT IS MORE -
IT WILL MIX PAINT - EFFICIENTLY |
MODEL
6 PAINT SHAKER - 1/3 HP
115/230 volts, 60 Hz, 1-phase, explosion proof motor and
timer, 10 ft., three wire cord.
Shipping weight, 215 lbs.
Dimensions, 33"x19"x30" high.
WILL
SHAKE:
1-GAL., 2-GAL., 5-GAL. CANS
OR A CARTON OF
4 - 1 GAL. CANS
| RIGHT
SIDE UP... |
| UPSIDE
DOWN, OR... |
| HORIZONTALLY! |
|
