Molding Pressure Transducers

Molding Pressure Transducers product information is presented by Cyronix Instrumentation & Controls. Molding Pressure Transducers sources are available by clicking on links below. Find Molding Pressure Transducers on cyronix.com with the terms Indirect Cavity Pressure Transducer, Direct Cavitiy Pressure Transducer, Amplified Output Nozzle Pressure Transducers, Amplified Nozzle Pressure Transducers, Molding Pressure Transducers.

Molding Pressure Transducers
The FT444DH measures plastic melt pressure in the mold cavity by sensing the force via an ejector or sensing pin. The force on the sensing pin is directly proportional to the cavity pressure. Model FT444DH mounts by sliding into a slot machined in the mold ejector plate or support plate, with its sensing button resting behind the pin. The FT444DH can be interchanged between molds to minimize the number of transducers required.

Molding Pressure Transducers
The FT445 and FT446 measure plastic melt pressure in the mold cavity by sensing the force applied via an ejector or sensing pin. The force generated by the ejector pin is directly proportional to the area of the pin multiplied by the cavity pressure. All models can be permanently installed in the mold ejector plate or support plate. The FT446H features a box - mounted connector. The FT446HM features a flush - mounted connector. The FT445 is a lower cost model and is supplied without a connector.

Direct Cavity Pressure Transducer
The PT449 is a miniature pressure transducer that mounts directly in the mold, flush with the cavity surface. The transducer does not depend upon knockout pins, thus eliminating pin hangup and improving measurement accuracy. The PT449 is used to measure peak cavity pressure, the most accurate and repeatable way to initiate the holding pressure phase.

Molding Pressure Transducers
Models PT4654XL, PT4655XL and PT4656XL measure polymer melt pressure in an injection molding machine nozzle or a hot runner. A protective flexible armored cable extends from its electronic housing to the tip for unmatched strength and increased life. Each model has a built - in amplifier to provide 4 - 20 mA (PT4654XL), 0 - 5 VDC (PT4655XL), or 0 - 10 VDC (PT4656XL) output to data acquisition or SPC/SQC programs. The amplified signal offers better resistance to noise than standard mV/V strain gage outputs.

Molding Pressure Transducers
The PT465XL measures polymer melt pressure in an injection molding machine nozzle or a hot runner. A protective flexible armored cable extends from its electronic housing to the tip for unmatched strength and increased life. Located in the nozzle, the PT465XL provides a very accurate measurement of the pressure of the plastic melt entering the mold..

Amplified Nozzle Pressure Transmitters
Models PT4674, PT4675, and PT4676 Amplified Nozzle Pressure Transmitters offer a 0.06" exposed diameter capillary to allow a 1/16" radius bend for mounting in tight spaces. Each model has a built - in amplifier to provide 4 - 20 mA (PT4674), 0 - 5 VDC (PT4675), or 0 - 10 VDC (PT4676) output to a DCS or computer system.

Solid State Pressure Switch
Model PT160SW Solid State Pressure Switch monitors hydraulic pressure on an injection molding machine. The switch is designed to energize a contact closure when setpoint pressure is reached. Unlike mechanical switches, the PT160SW can handle the severe demands of cyclic pressure and overpressure without failing. Field failures mean service calls, frustration and lost production time.