-
Flow
rate range: 0.72 to 5800 mL/min
Flow rate depends on tubing size.
-
Controller
simultaneously controls up to four DIGI-STALTIC pump drives.
Transfer four fluids at the same flow rate, or vary each
independently.
-
Save
up to 30 programs into memory.
No need to reprogram the controller once you have your
application set up.
-
Control
all functions of the DIGI-STALTIC pump through your PC.
Software is included that is compatible with WINDOWS®
95 and WINDOWS NT®.
-
Two
sets of NO and NC contacts.
Provide "pump running" and "cycle running" signaling at
each pump drive.
-
Directly
input volumes, flow rates, and speed range using the 20-key,
tactile-feedback keypad.
Flow range is determined by tubing selection.
-
Remote
control capabilities via one contact closure on each drive.
Offers on/off control with dispensing handle (included)
or footswitch.
-
Reversible
1/10-hp motor.
Purge tubing before or after pumping; pump fluid in either
direction.
-
No
need to calibrate when changing volumes.
Controller saves you time by holding calibration settings.
-
±
0.3% speed control.
Pump or dispense with accuracy and precision.
-
Runs
on 115 VAC or 230 VAC.
Drive is switch selectable to meet your needs.
-
Both
drive and controller are enclosed in an IP22-rated gray
housing.
Units are protected against vertically falling water and
incidental splashes.
-
3
1/2-ft RJ-12 cord is included for easy connection between
drive and controller.
10-ft and 15-ft cables are available. Position drive(s)
and controller where most convenient.
-
User-friendly,
menu-driven keypad facilitates direct data entry.
Eighty character (2 x 40), backlit liquid-crystal display
is easy to read.
-
Pump
drive features a seven-digit LED on front panel.
Drive tells you exactly which pump is in use when plugged
into the controller.
-
6-ft
(1.8-m) line cord - 115 VAC: U.S. standard plug; 230 VAC:
IEC 320/CEE22 socket.
Please specify country of destination to receive correct
plug/cord set.
This
new DIGI-STALTIC dispensing pump system delivers a remarkable
combination of performance versatility and ease-of-use. Use
it as a dispenser, diluter, or general-purpose transfer pump.
Ideal for pharmaceutical, research lab, biotech, and food
pilot plant applications. The modular format allows you to
control up to four drives from one controller, and the easily
programmable options enable you to operate each drive independently.
To deliver the high accuracy essential to dispensing applications,
each drive includes two stacked pump heads in tandem with
offset rollers that produce constant flow rates with virtually
no pulsation. For weight dispensing applications, the controller
features a balance-compatible RS-232 connector for direct
connection to an electronic balance.
