|
The
General Water
Pollution Control Barrels are low cost, self contained
water purification Adsorbers designed to treat liquid
Activated Carbon The General liquid absorbers are filled with virgin, high activity GC 8x3O carbon. Virgin GC 12x40, reactivated GC 8x3OR or other special carbons are also available. Removable Lid 6 gauge lid with ring & bolt closure and poly clad cellulose gasket. Connections Metal connections with standard pipe threads insure easy, durable and leakproof hookup to your system. Unions or quick connect fittings are advised to make drum exchange easy. Flow Distributors Both inlet and outlet have low pressure drop, slotted Schedule 40 PVC distributors. Units work well in either an upflow or downflow manner when the start up procedure is followed. Stainless Steel internals and drums are available for special applications. Coatings The General water pollution control barrels are coated on the inside with heat cured phenolic epoxy. The outside coating is industrial enamel. A polyethylene liner is available for extra corrosion resistance for the 55 gallon and 85 gallon units. Installation & Start Up If possible, before the units are used for the first time, they should be filled with clean water for a period of 8 to 12 hours to allow the carbon to degas. A gentle backwash is also recommended to remove carbon fines that can cause excessive pressure drop through the unit. Multiple units are usually connected in series with testing between the units advised to determine when the first unit needs to b6 changed out. Maintenance Once connected, The General requires no maintenance other than the monitoring of the influent and effluent liquid streams and the operating pressure of the system. Monitoring the liquid stream into the last Water Pollution Control Barrel in series mode is a recommended safeguard against breakthrough in the final outflow. When the concentration of contaminants in the outflow equals the concentration in the inflow, The General has reached its removal capacity and should be removed from service. The working life of each absorber is dependent upon the type of contaminant in the water as well as its concentration and the liquid flow rate. A pressure relief device is advised to prevent damage to the canister in the event of excessive pressure buildup. Recharging The General Once the carbon is saturated by contaminants; the unit should be removed and replaced with a fresh one. To purchase replacement carbon or to arrange for a carbon change out, please contact our office. Disposal Dispose of the spent carbon in accordance with Federal, State and Local regulations.  |
The General: Liquid Adsorbers| Filter
Innovations Inc ACTIVATED CARBON FILTRATION SYSTEMS Introduction AIR PHASE CARBONS Air Phase Carbons F Series Adsorbers ES Series Adsorber ET Series Adsorbers The General TV Series Adsorbers LIQUID PHASE CARBONS Liquid Phase Carbons FRP Series Adsorbers J Series Adsorbers The General TL Series Adsorbers |
AMIAD
FILTRATION SYSTEMS Automatic Filter Systems ABFL Automatic Filters EBF Automatic Filters SAF Automatic Filters TAF Automatic Filters Plastic Water Filters & Strainers Steel Water Filters & Strainers Visit Filter Innovations Web Site |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
